INSTRUCTION MANUAL:
DEER GARD SILENT DEER REPELLER
I. INTRODUCTION
Bird-X, Inc. has been recognized worldwide as the bird and pest control experts for more than
40 years and its specialists are able to analyze problems and make recommendations based on
each customer's specific situation and needs.
II. WHY CONTROL DEER?
Deer are extremely destructive to plants, gardens, vegetables, flowers, trees and more.
Deer ticks carry lyme disease.
III. DEER MANAGEMENT PROGRAM
A. Survey the deer and their entry, exit and feeding habits.
B. Inspect your property. Discover what the deer find attractive about your area, and if the same conditions prevail in
neighboring properties.
C. Maintain a changing environment. For maximum effectiveness, periodically relocate or reposition the unit, vary the
output, or turn it off for a short time.
D. Install early. It is always best to install the DeerGard before "deer season" begins, as it is easier to keep them away
than to rout them out once they have already established a pattern.
E. Use products synergistically. Two or more different kinds of devices (DeerGard plus netting and/or a taste or smell
aversion) will produce a synergistic effect --i.e., in combination, the products will yield much greater effectiveness than
the DeerGard alone. Contact Bird-X, Inc. for information on "companion" products.
F. Consider alternate locations. Make educated guesses as to where the deer will go when they leave their current
infestation area, and consider purchasing units to cover these areas as well.
IV. UNIT OVERVIEW
This adjustable-frequency, dual-operation, weatherproof unit repels deer. (The unit can also repel cats, dogs,
armadillos, rodents, bats, insects and raccoons). An infrared motion sensor is built in.
V. UNIT SET-UP
Gently pull off the back cover. Set the operation switch (upper right) to OFF.
Turn the frequency dial (upper left) to the desired pest.
On the operation switch, choose "MS AC or Battery" for the unit to operate
briefly each time the motion sensor is tripped (works with both an AC adapter
and batteries), or choose "CONT. AC Only" for the unit to operate
continuously (works with an AC adapter only).
Turn "Sensitivity" dial to adjust motion sensor sensitivity.
AC Adapter Plug one end into the port underneath the operation switch and
the other into any standard outlet. (If using outside, protect the outlet from
weather). Run the cord through the notch on the bottom of the unit. Snap the
cover back into place.
Batteries Install four "C" batteries as shown on the unit. Snap the cover back
into place.
Expect coverage up to 4000 square feet in a generally oval pattern
approximately 80 feet out in front of the unit, 50 feet wide. The speaker
projects sound on a horizontal plane in one direction. The lower the sound
frequency (clockwise), the greatest coverage. In dense foliage and/or large acreage, multiple units may be necessary.
VI. INSTALLATION
Use the keyhole slots on the back to mount it on any building, wall or wooden post with nails or screws.
Point the speaker at the area you want covered. If installing outdoors, place the unit at least 3 feet above the ground for
optimum range.
(2 pages)
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals